Quick Answer: Can You Put Too Much Insulation In Your Attic?

How many inches of insulation should be in my attic?

The recommended level for most attics is to insulate to R-38 or about 10 to 14 inches, depending on insulation type..

Is it OK to insulate roof rafters?

Insulating between rafters will do no good, because the attic should be ventilated, and the rafter insulation would be between two unheated spaces. … Moisture buildup in the attic is a concern because it can condense into water, often causing mold. Good ventilation, from soffit vents and a ridge vent, will stop that.

The Government say that you cut your energy bill by up to 20% through effectively insulating your loft. The recommended depth for loft insulation is 270 millimetres for glass wool, 250 millimetres for rock wool or 220 millimetres for cellulose.

Is there such thing as too much insulation in the attic?

It is possible to over-insulate your house so much that it can’t breathe. The whole point of home insulation is to tightly seal your home’s interior. But if it becomes too tightly sealed with too many layers of insulation, moisture can get trapped inside those layers. That’s when mold starts to grow.

Can you put too much blown insulation in your attic?

There’s really no such thing as “too much insulation.” It is more likely that your attic is not ventilating properly, resulting in warmer air on the 2nd floor and an overheated attic.

Is it better to insulate attic ceiling or floor?

1 Answer. Since the ceiling in the attic is too low to make it into a living space, you should only insulate the floor. Insulating the ceiling will create a new heating zone, and essentially you will be paying more to heat your attic. … When you are done, you should have a “carpet” of insulation on the floor.

How much does it cost to insulate a 1500 sq ft attic?

Attic insulation costs $1 to $7 per square foot, depending on type and the size of your home. Most homeowners pay $1,500 to $2,000….Attic Insulation Cost Per Square Foot.Square FeetPrice1,000$1,000 – $7,0001,500$1,500 – $10,5002 more rows

How long does Attic Insulation last?

20 to 30 yearsThe typical lifespan is 20 to 30 years, with degradation beginning as early as 15 years after installation. As with other types of insulation, severe weather or outside interference can reduce the lifespan. Note: cellulose is often used as supplementary insulation.

Is rolled insulation better than blown?

Rolled fiberglass insulation scores an R-value of 3.7. So overall, rolled fiberglass insulation is slightly more effective at blocking in and out heat than its blown counterpart.

Can you lay insulation over electrical wires in attic?

Don’t step on any cables or wires in the attic. … Insulation in contact with the wires can cause it to overheat and start the black wire insulation on fire. You also need to be on the lookout for any older recessed lighting fixtures. Many of these can have wires that feed them that can catch on fire if they overheat.

How do you install attic insulation over existing?

As described above, lay unfaced fiberglass or mineral insulation over the existing insulation. Just remember to run it perpendicular to the joists. You can also top off existing insulation with loose fill fiberglass or cellulose, but fiberglass or mineral wool batts are easier and neater to install.

Can you have too much insulation in your loft?

As long as you ventilate your property properly, you can have as much insulation as you like within reason. The trick with loft insulation is to balance the amount of insulation you have with the amount of ventilation necessary to prevent damp. … Again, as long as the loft has adequate ventilation, this is fine.

Which type of insulation is best for attic?

FiberglassBlown-in. Also known as loose-fill, blown-in insulation comes in tiny chunks packaged in large bags, and entails using a blowing machine to fill in necessary spaces. Fiberglass, cotton, and mineral wool can all work as loose-fill material, but the far and away top choice for blown-in insulation is fiberglass.

How can I insulate my attic cheaply?

While insulating your attic space with foam can be an effective way to lower heating costs, you can use a simple reflective foil material as a cost-effective alternative. By stapling the foil sheets to your attic roof rafters, you can reflect the heat that hits the rafters back down into your home’s living space.

Can poor insulation cause condensation?

Even after a system is insulated, condensation may still form as a result of a miscalculation or poor installation. … The insulation must also be installed correctly; any gap in insulation or any small opening in the vapor retarder will lead to condensation and must be sealed immediately.

How much money will insulating my attic save me?

EPA estimates that homeowners can save an average of 15% on heating and cooling costs (or an average of 11% on total energy costs) by air sealing their homes and adding insulation in attics, floors over crawl spaces, and accessible basement rim joists.

How much does it cost to insulate a 1000 sq ft attic?

The cost to insulate an attic with blown-in insulation runs from $600 to $1,200, assuming it is 1,000 square feet in size. If you choose to hire a professional, expect to pay from $40 to $70 an hour for labor in addition to the cost of materials.

Should you remove old attic insulation before adding new?

According to ENERGY STAR®, you can put new insulation over old insulation, “unless it is wet. … “Faced” insulation should not be placed on top of existing insulation in the attic. Any new roll or batt insulation installed over existing insulation in the attic needs to be without a vapor retarder (face).

Is it worth it to add insulation to attic?

According to the Department of Energy, properly insulating the attic can save 10 to 50 percent on a typical heating bill. … For many homeowners, insulating the attic is the most effective method to save on energy costs.

How do I know if my attic needs more insulation?

Looking across your attic, if the insulation is level with or below the attic floor joists, you probably need to add more insulation. Assumes R-3/inch. If you cannot see any of the floor joists because the insulation is well above them, you probably have enough, and adding more insulation may not be cost-effective.